Cleaning Cautions - Remington HC5880 Mode D'emploi

ENGLISH
, STEP 5 – The finishing touches
• Use the clipper without an attachment comb for close trimming around the
base and sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper. Place
the reversed clipper at right angles to the head, tips of the blades lightly
touching the skin and then work downwards.
, SHORT TAPERED STYLES – "FLAT TOPS" & SHORT CUTS
• Starting with the longest fixed comb (25mm), cut from the back of the neck to
the crown. Hold the guide comb flat against the head and slowly move the
clipper through the hair.
• Use the same procedure from the lower side to the upper side of the head.
Then cut the hair against the direction in which it grows and level with the
sides.
• To give a "flat top" look, the hair on top of the head must be cut over the top
of a flat comb.
• Use a closer guide comb to taper the hair down to the neckline as desired.
C CARE FOR YOUR HAIRCLIPPER
, AFTER EACH USE
• Ensure the appliance is switched off and unplugged from the mains before
cleaning.
• Brush the accumulated hair from the blades. The blades and product unit can
be rinsed under the tap. Please see cleaning section below on this.
• It is recommended that the blades should be removed, and any accumulated
hair be brushed out after each use. 1 or 2 drops of clipper oil should be added
to tip of blades, and a drop on the back gliding surfaces.
, REMOVING AND REATTAHCING THE BLADE SET
• The blades can be released by placing your finger or thumb into the push
release point and sliding the blade off the product unit.
• To reattach place the blade set on top of the product unit and slide this gently
into place until you hear and feel it click into place.

, CLEANING CAUTIONS

• This clipper is fully washable. The clipper and blade set can be rinsed under
the tap for cleaning. Only rinse the blades when needed.
• For a deep clean, let the blades run while rinsing under the tap.
• Please ensure the product is fully dried after, especially the blade set surfaces.
• Caution: do not wash when plugged into the mains power.
6