Every Six Months; Cleaning Cautions - Remington PROPOWER Mode D'emploi

ENGLISH
• Push the button that is located on the front of the hair clipper. The blades will
slide out and the blade set can be easily cleaned under the tap.
• Once the blades are cleaned the blades are locked into place by pushing the
blade set towards the hair clipper head and will snap into place.
• Do not run the entire unit under the tap, only the blade set is meant to be
submerged in water.
Note: Ensure the clipper is turned off when cleaning.

, EVERY SIX MONTHS

• At regular intervals the blade set should be removed and cleaned.
• Remove the 2 screws retaining the fixed blade with a screwdriver. Do not
remove blade set.
• Brush out hairs from between the blades with soft cleaning brush. Do not
remove the lubricating grease from the blades. It is not necessary to remove the
small moving blade from the unit.
• If the moving blade has been removed this can be re-fitted by slotting the
coated blade holder over the pin in the centre of the interior product head. The
groove on the coated blade, just below the teeth, rests on a metal plate at the
opposite side to the screw holes. The fixed blade is fitted with the raised profile
pointing outwards and fixed with the 2 screws.
• Note that if the blades are not correctly aligned then cutting efficiency will be
impaired.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe off
excess oil.

, CLEANING CAUTIONS

• Ensure the appliance is switched off and unplug from the main outlet before
cleaning.
• Only the attachment guide combs and trimmer blade may be removed from
the product for cleaning.
• Cleaning should be done with a soft brush, such as the brush supplied with the
product.
• Do not rinse under water.
• Do not use harsh or corrosive cleaners on the units or their blades.
8