After Each Use - Remington PROPOWER Mode D'emploi

ENGLISH
, SHORT TAPERED STYLES – "FLAT TOPS" & SHORT CUTS
• Starting with the longest guide comb attached (24 - 42mm), cut from the back
of the neck to the crown. Hold the guide comb flat against the head and slowly
move the clipper through the hair.
• Use the same procedure from the lower side to the upper side of the head.
Then cut the hair against the direction in which it grows and level with the
sides.
• To give a "flat top" look, the hair on top of the head must be cut over the top of
a flat comb.
• Use a closer guide comb to taper the hair down to the neckline as desired.
, DUAL BOOST SYSTEM (HC5600)
• There are 3 settings for the Dual Boost system: Off, On, Boost.
• If the clipper is set to on, it will run at regular power.
• If the clipper is set to boost, it will provide maximum power.
, AUTO BOOST SYSTEM (HC5800)
• There are 3 settings for the Auto Boost system: Off, Auto, Boost
• If the Clipper is set to Auto, it will run at regular power under low load
conditions.
• When more power is needed, the clipper will automatically sense this and
provide maximum boost.
• To activate the Boost setting, depress the power button for 2 seconds. The
clipper will then constantly run at maximum power.
C CARE FOR YOUR HAIRCLIPPER
Your clipper is fitted with high quality blades. To ensure long lasting performance
of your clipper, clean the blades and unit regularly. Always keep the attachment
guide comb on the trimmer blade.

, AFTER EACH USE

• Ensure the clipper is switched off and disconnected from the mains before
cleaning.
• Brush the accumulated hair from the blades. Do not submerge the clipper in
water.
• To clean unit, wipe with damp cloth and dry immediately.
, WASHABLE CLEANING
• The QUICK WASH SYSTEM is designed to maximise the efficiency of washable
cleaning.
7