After Each Use; Battery Removal - Remington NE3850 Mode D'emploi

ENGLISH
C CARE FOR YOUR TRIMMER
• Care for your product to ensure a long lasting performance. We recommend
that you clean your trimmer after each use.
• For best results, keep trimmer running while running it under the tap. Allow
water to run through the washout port and over the blades. Press the Active
BladeClean system button while rinsing to flush water through the blades.
• Dry off excess water.
• Do not submerge in water as damage will occur.
E TROUBLESHOOTING
• The trimmer is not running but has battery power left:
• If the trimmer is not running it may need cleaning; look for and remove any
dried debris from the cutting blades and then press the Active BladeClean
system button whilst rinsing the trimmer under running water.

, AFTER EACH USE

• Rinse the accumulated hair from the cutters as noted above. Ensure all debris
is removed from between the blades and then press the Active BladeClean
system button and shake off excess water.

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
• Rotate the battery compartment cap approximately ¼ turn anti-clockwise
then pull off.
• Remove the battery from the battery compartment.
• Place the cap back on the unit opposite to how it came off and rotate
clockwise until the cap snaps into place.
• The battery is to be disposed of safely.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous
substances in electrical and electronic goods, appliances marked with
this symbol must not be disposed of with unsorted municipal waste,
but recovered, reused or recycled.
6