After Each Use - Remington Touch Control Lithium Hair Clipper HC5960 Mode D'emploi

ENGLISH
C CARE FOR YOUR HAIRCLIPPER
• Your clipper is fitted with high quality blades.
• To ensure long lasting performance of your clipper, clean the blades and unit
regularly.
• Always keep the attachment guide comb on the trimmer blade.

, AFTER EACH USE

• Ensure the appliance is switched off and unplugged from the mains before
cleaning.
• Remove the attachment guide comb.
• Gently brush the remaining hairs away from the comb and trimmer blade.
• Do not rinse the cutter assembly under water.
• We recommend oiling the blades after cleaning with a little sewing machine
oil.
, RESET INSTRUCTIONS
• You will never have to force a system reset under normal conditions. If the
clipper experiences abnormal behaviour, such as low or high touch sensitivity
or subjected to electrostatic discharge disturbance, or subjected to electrical
fast transient/burst from the LV network, the system can be reset.
• Hold the mode button for 8 seconds with the product switched on and the 3
position slide switch set to the middkle position, the system will enter reset
mode.
• System will show 88.8mm, full battery, full lock and full boost level.
• Ensure no objects, hands or fingers are near the touch buttons.
• Push the mode button once.
• The comb will travel down to its lowest setting and the display will show the
current battery level, lock status and 1st boost level.
• Let the product sit until the screen dims.
• Product is now ready, turn it on and confirm proper function.
C CLEANING CAUTIONS
• Only the attachment guide combs and trimmer blade may be removed from
the product for cleaning.
• Cleaning should be done with a soft brush.
• The appliance is not washable.
• Do not rinse under water.
• Do not use harsh or corrosive cleaners on the units or their cutters.
• Note: these clippers are not intended for professional use.
8