Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
, STEP 4 – Top of the head
•
With the 18mm or 22mm guide comb attached, cut hair on top of the head
against the direction in which the hair normally grows.
, Note: For longer desired lengths of more than 22mm, place finger over hair
and guide into the guide comb and blade to better guide the hairs
trimmings into the vacuum chamber.
•
Always work from the back of the head.
, STEP 5 – The finishing touches
•
Use the clipper without a guide comb for close trimming around the base
and sides of the neck.
•
To produce a clean straight line at the sideburns, reverse the hair clipper.
•
Place the reversed clipper at right angles to the head, tips of the blades
lightly touching the skin and then work downwards.
, SHORT TAPERED STYLES – "FLAT TOPS" & SHORT CUTS
•
Starting with the longest guide comb attached (25mm), cut from the back
of the neck to the crown. Hold the guide comb flat against the head and
slowly
move the clipper through the hair.
•
Use the same procedure from the lower side to the upper side of the head.
•
Then cut the hair against the direction in which it grows and level with the
sides.
•
To give a "flat top" look, the hair on top of the head must be cut over the top
of a flat comb.
•
Use a closer guide comb to taper the hair down to the neckline as desired.
C CARE FOR YOUR HAIRCLIPPER
•
To ensure long lasting performance of the clipper, clean the blades and unit
regularly.
•
Ensure the appliance is switched off and unplugged from the mains outlet
before cleaning
•
Do not use harsh or corrosive cleaners on the units or their cutters.
•
Cleaning should be done with a soft brush.
, AFTER EACH USE
•
Brush the accumulated hair from the blades.
•
To clean the unit, wipe with a damp cloth and dry immediately.
, Note: To maintain the effective vacuum performance of the clipper,
regularly brush or rinse fine hairs in the mesh panel found at the base of the
vacuum chamber.
7
Publicité
Table des Matières
