Every Six Months; Cleaning Cautions; Removing The Rechargeable Battery - Remington HC7170 Mode D'emploi

ENGLISH
• To reattach once the blades are cleaned and dry, align the bottom of the blade with the
bottom blade housing tab and slide the cartridge back into place until you hear a click.
• Do not run the entire unit under the tap, only the blade set is meant to be submerged in
water.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.

EVERY SIX MONTHS

• Remove the 2 screws retaining the fixed blade with a screwdriver.
• Remove the blade set.
• Brush out hairs from between the blades with a soft cleaning brush. Do not remove the
lubricating grease from the blades. It is not necessary to remove the small moving blade
from the unit.
• If the moving blade has been removed this can be re-fitted by slotting the moving
blade holder over the pin in the centre of the interior product head.
• The groove on the moving blade just below the teeth should rest on the plastic pressure
arm which rides inside the groove. The fixed blade should be assembled with the
bevelled edge of the 2 screw holes facing outward and fixed with screws.
• Note that if the blades are not correctly aligned then cutting efficiency will be impaired.

CLEANING CAUTIONS

• Do not use harsh or corrosive cleaners on the units or their blades.
• Ensure the appliance is switched off and unplug from the main outlet before cleaning.

REMOVING THE RECHARGEABLE BATTERY

We strongly recommend that a professional removes the rechargeable battery. Parts of the
shaver case, and tools have sharp edges and may cause injury if not handled correctly.
• The rechargeable battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.
1. Ensure that the battery is fully discharged. To do this, operate the trimmer until it stops.
2. Remove the comb attachment.
3. Detach the blade cartridge.
4. Pry the decorative panel off the top housing to expose the 6 screws located in the inner
housing.
5. Unscrew the 6 screws.
6. Pry the inner housing apart from bottom housing to expose the internals and printed
circuit board.
7. Remove the battery and printed circuit board assembly from the battery chamber.
8. Disconnect the battery from the circuit board.
• The battery must be disposed of at an appropriate official recycling/collection point.
• Do not attempt to operate the trimmer once you have opened it.
8