Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 2 – BACK OF THE HEAD
•
With the comb set at 12mm or 18mm, cut the hair at the back of the head.
STEP 3 – SIDE OF THE HEAD
•
With the comb set at 3mm or 6mm, trim sideburns. Then change to the longer 9mm
guide comb and continue to cut the top of the head.
STEP 4 – TOP OF THE HEAD
•
Use the longer length comb attachment and set it to 24mm or 27mm then cut hair on
top of the head against the direction in which the hair normally grows.
•
For longer hair on top, use the longer length comb attachment (24 – 44mm) to achieve
the desired style.
•
Always work from the back of the head.
STEP 5 – THE FINISHING TOUCHES
•
Use the clipper without an attachment comb for close trimming around the base and
sides of the neck.
•
To produce a clean straight line at the sideburns, reverse the hair clipper.
•
Place the reversed clipper at right angles to the head, tips of the blades lightly touching
the skin and then work downwards.
AUTO TURBO SYSTEM
•
Push the power button and the appliance runs in Normal Mode. The Auto Turbo will
automatically activate when the clipper senses it needs more power.
•
To run in Turbo mode, hold down the power button for 2 seconds and the clipper will
run in boost until it is turned off.
CARE FOR YOUR HAIRCLIPPER
•
Your clipper is fitted with high quality blades.
•
To ensure long lasting performance of your clipper, clean the blades and unit regularly.
•
Always keep the attachment guide comb on the trimmer blade.
AFTER EACH USE
•
Ensure the appliance is switched off and unplugged from the mains before cleaning.
•
Brush the accumulated hair from the blades and body of the clipper. Do not submerge
the clipper in water.
•
To clean unit, wipe with a damp cloth and dry immediately.
•
Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
WASHABLE BLADE CLEANING
This clipper is fully washable and therefore can be rinsed under a running tap. However,
avoid getting the micro USB port wet.
•
To remove the blades ensure the unit is off. Press the blade release button on the back
of the clipper where it meets the blade and push away from the clipper.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
BG
AE
7
Publicité
Table des Matières
