Every Six Months; Battery Removal - Remington HC5880 Mode D'emploi

ENGLISH
• Once the blade set is fully dried, to enhance performance and prolong the
life of your clipper, we strongly recommend for you to oil the blades. To be
properly oiled, the blade set needs to be removed, so drops of oil can be
added to the back gliding surface.

, EVERY SIX MONTHS

• At regular intervals the blade set should be removed and cleaned.
• Remove the 2 screws retaining the fixed blade with a hex screwdriver. Do not
remove blade set.
• Brush out hairs from between the blades with soft cleaning brush. Do not
remove the lubricating grease on the plastic components. It is not necessary
to remove the small moving blade from the unit.
• Take out the hex screws and disassemble the blade set. Brush and clean out
accumulated hair. Oil the contact surfaces of the blades and then
reassemble.
• If the blades are not correctly aligned, cutting efficiency will be impaired.
• Place a few drops of clipper oil onto the blades gliding surface. Wipe off
excess oil.
C CLEANING CAUTIONS
• Ensure the appliance is switched off and unplug from the main outlet before
cleaning
• Only the attachment guide combs and blade set may be removed from the
product for cleaning.
• Do not use harsh or corrosive cleaners on the units or their blades.
• Suitable for cleaning under an open water tap

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
• Ensure that the clipper is discharged of all power and disconnected from the
mains
• Lift or pry the deco plate on the lower portion of the clipper and unscrew 2
screws located on the back housing of the clipper.
• Remove 4 screws of inner housing to expose batteries
• Lift or pry the cover plate on the bottom of the battery chamber.
• Remove the 2 batteries and printed circuit board assembly from the battery
chamber.
7