Remington HC5880 Mode D'emploi page 5

ENGLISH
F INSTRUCTIONS FOR USE
, Before starting the cut
• Inspect the clipper making sure that it is free from hair and dirt.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
, TO ATTACH A COMB
• Hook front side of attachment comb on front side of teeth.
• Press back side of comb downwards, until the tab clicks into place.
, TO REMOVE THE COMB
• Press upward on the tab to release the comb.
• With tab released, pull comb away from clipper and unhook front of the
blade.
, INSTRUCTIONS FOR CUTTING HAIR
• For even cutting, allow the comb attachment/blade to cut its way through
the hair. Do not force it through quickly. If you are cutting for the first time,
start with the maximum comb attachment.
, STEP 1 – Nape of the neck
• Attach the 3mm or 6mm fixed comb
• Hold the clipper with the blade teeth pointing upwards. Begin starting at the
centre of the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair,
trimming just a little at a time.
, STEP 2 – Back of the head
• With the 12mm or 16mm guide comb attached, cut the hair at the back of
the head.
, STEP 3 – Side of the head
• With the 3mm or 6mm guide comb attached, trim sideburns. Then change to
the longer 9mm guide comb and continue to cut the top of the head.
, STEP 4 – Top of the head
• Use the longer length fixed combs of 22mm or 25mm to cut hair on top of
the head against the direction in which the hair normally grows.
• Always work from the back of the head.
5