Cleaning Cautions; Battery Removal - Remington HC335 Mode D'emploi

ENGLISH
•
Brush the accumulated hair from the blades and the hair pocket. Do not
submerge the clipper in water.
•
After cleaning close the hair pocket.
•
Place one or two drops of oil on the blades. Turn the clipper on to distribute
the oil evenly, wipe off any excess oil. Excess oil will cause damage to the
product.
•
To clean the unit, wipe with a damp cloth and dry immediately.
, NOTE: Ensure that the clipper is turned off when cleaning.

, CLEANING CAUTIONS

•
Cleaning should only be done with a soft brush, such as the brush supplied
with the product.
•
Only use the light-grade oil supplied or sewing machine oil on the blades.
•
Do not use harsh or corrosive cleaners on the units or their blades.
•
Do not submerge in water as damage will occur.

BATTERY REMOVAL

•
The appliance must be disconnected from the supply mains when removing
the battery.
•
Ensure the clipper is discharged of all power.
•
First remove the comb.
•
Open the hair pocket (Diagram H).
•
Unscrew 2 screws in the hair pocket with a screwdriver.
•
Unscrew the screw on the back housing of the clipper (Diagram I).
•
Lift or pry the clipper halves apart, exposing the battery.
•
Cut the wires on both ends of the battery and remove it from the clipper.
•
The battery must be removed from the appliance before it is scrapped.
•
The battery is to be disposed of safely.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous
substances in electrical and electronic goods, appliances marked with
this symbol must not be disposed of with unsorted municipal waste, but
recovered, reused or recycled.
7