Remington HC335 Mode D'emploi page 5

ENGLISH
, BEFORE STARTING THE CUT
•
Inspect the clipper making sure it is free from hair and dirt.
•
Seat the person so that their head is approximately at your eye level.
•
Before cutting, always comb the hair so it is tangle free and dry.
, TO ATTACH A COMB
•
Hold the clipper vertically.
•
Line the comb rails up with the vertical channels on the sides of the clipper
and slide the comb all the way until it stops.
, NOTE: Please make sure that the comb locking mechanism is not activated
(the switch on the back of the clipper should be in the down position when
attaching a comb).
, TO REMOVE A COMB
•
Holding the clipper with the blades facing away from you, firmly push the
comb upward and away from the blades.
, NOTE: Please make sure that the comb locking mechanism is deactivated
(the switch on the back of the clipper should be in the down position when
removing the comb).
, ADJUSTING THE TRIM LENGTH
•
The comb attachment can be adjusted to give you 4 different trim lengths.
•
Move the comb up or down to the preferred setting and slide the switch on
the back of the product up to lock the comb. To unlock, slide the button
down.
Comb Position
1
2
3
4
•
1mm length is achieved without any combs.
•
0.5mm is achieved without any combs and holding the blades
perpendicular to the skin.
, INSTRUCTIONS FOR CUTTING HAIR
, Note: for even cutting, allow the comb attachment/blade to cut its way
through the hair. Do not force it through quickly. If you are cutting for the
first time, start with the highest setting.
Short Comb
6mm
9mm
12mm
15mm
Long Comb
18mm
5