Operation - Klarstein VIRTUOSA SLIDE Mode D'emploi

EN
32

OPERATION

To start cooking
After power on, the buzzer beeps once, all the indicators light up for 1 second then go
out, indicating that the ceramic hob has entered the state of standby mode.
1 Touch the ON/OFF control all the indicators show [-] or [--], indicating that the
ceramic hob has entered the state of standby mode.
2 Place a suitable pan on the cooking zone that you wish to use. Make sure the
bottom of the pan and the surface Of the cooking zone are clean and dry.
3 Touching the heating zone selection control, and a indicator next
to the key will flash.
4 Set a power level by touching the [-], [+], or slide along the [—]control, or just touch
any point of the [—]:
Important Notes
• If you don't select a heat zone within 1 minute, the induction hob will automatically
switch off. You will need to start again at step 1.
• You can modify the heat setting at any time during cooking.
• If slide along the [—], power will vary from stage 2 to stage 8. Press [-], power will
decrease by one stage each time till stage 0. Press [+], power will increase by one
stage each time till stage 9.
• When zone 1 or 3 is working, activate dual zone or oval zone by pressing [
When dual zone or oval zone is working, turning off it by pressing [
],
].