Assembly Procedure - Rehau RAUTOOL M1 Mode D'emploi

RAUTOOL M1

AsseMBLy pROcedURe

Failure to observe these instructions may result in damage to the jointing system or to the tool and can cause personal injury .
1. Using pipe cutters, cut pipe to required length at right angles and
without leaving burrs.
Caution:
Keep your hand at a safe distance from the tool. Do not use saws or
similar!
2. Slide compression sleeve onto pipe, ensuring that the inside taper
points towards joint.
Caution:
On metal compression sleeves, the inner chamfer must point towards
the connection!
3. Expand pipe using expander or expander bit: rotate 30°, and
repeat. The min. distance between expander head and compression
sleeve must be one compression sleeve length.
4. Insert the fitting into the pipe up to the stop. Insert fitting into pipe
up to the stop. After a brief period the fitting will sit tightly in the pipe
(memory effect).
Caution:
All sealing ribs must be covered! All sealing ribs must be covered.
Until the memory effect has set in completely, the fitting can fall out
of the pipe! Make sure that the fitting is correctly seated.
5. Insert the joint fully into the clamping tool.
Caution:
Do not tilt. Tool must be applied over full surface and at right angles.
24