Maintenance; Inspection And Maintenance Plan - HOLZMANN MASCHINEN BF500D Mode D'emploi

Examples of speeds:
Cutter: Ø 2 mm
6 m/min 955 min
8 m/min 1274 min
10 m/min 1592 min
12 m/min 1911 min
CLEANING
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil.
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Therefore, clean the device after each use of chips and dirt particles.

MAINTENANCE

Danger due to electrical voltage! Handling the machine with the power supply up
may result in serious injury or death. Always disconnect the machine from the power
supply before servicing or maintenance work and secure it against unintentional
restart!
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless, any
faults or defects which may affect the safety of the user must be rectified immediately!
 Before each start-up, make sure that the safety devices are in perfect condition and
function properly.
 Check all connections for tightness at least once a week.
 Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.
 Use only proper and suitable tools.
 Only use original spare parts recommended by the manufacturer.
21.1

Inspection and maintenance plan

The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the specified limits:
Interval
Before start of work or
after every maintenance
or servicing
Weekly
HOLZMANN MASCHINEN GmbH
Ø 4 mm
-1 478 min -1 318 min
-1 637 min -1 425 min
-1 796 min -1 531 min
-1 955 min -1 637 min
NOTICE
WARNING
Component
Gear oil
Coolant
Screw connections
Moving parts
Guideways
Spindle
Ball bearing
www.holzmann-maschinen.at
Ø 6 mm Ø 8 mm
-1 239 min
-1 318 min
-1 398 min
-1 478 min
What to do?
Check and refill if necessary
Check and refill if necessary
Check for tightness
Lubricate
Lubricate
Lubricate with gear grease
Lubricate with gear grease
CLEANING
Ø 10 mm Ø 12 mm
-1 191 min -1 159 min
-1 255 min -1 212 min
-1 318 min -1 265 min
-1 382 min -1 318 min
BF500D | BF500DDRO
-1
-1
-1
-1
56