Safety Devices; General Safety Information - HOLZMANN MASCHINEN BF500D Mode D'emploi

Work on electrical components or equipment may only be carried out by a qualified
electrician or under the instruction and supervision of a qualified electrician.
15.3

Safety devices

The machine is equipped with the following safety devices:
15.4

General safety information

To avoid malfunctions, damage and health hazards when working with the machine, in addition to
the general rules for safe working, the following points must be observed:
 Before start-up, check the machine for completeness and function. Only use the machine if
the guards and other non-parting guards required for machining have been fitted, are in
good operating condition and have been properly maintained.
 Choose a level, vibration-free, non-slip surface for the installation location.
 Ensure sufficient space around the machine!
 Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
 Ensure a clean working environment.
 Keep the area around the machine free of obstacles (e.g. dust, chips, cut workpiece parts
etc.).
 Only use perfect tools that are free of cracks and other defects (e.g. deformations).
 Remove tool keys and other adjustment tools from the machine before switching it on.
 Check the machine connections for strength before each use.
 Never leave the running machine unattended. Switch off the machine before leaving the
working area and secure it against unintentional or unauthorised recommissioning.
 The machine may only be operated, serviced or repaired by persons who are familiar with
it and who have been informed of the dangers arising during this work.
 Ensure that unauthorised persons maintain a safe distance from the machine and keep
children away from the machine.
 When working on the machine, never wear loose jewellery, loose clothing, ties or long,
open hair.
 Hide long hair under hair protection.
 Wear close-fitting protective clothing and suitable protective equipment (eye protection,
dust mask, ear protection; gloves only when handling tools).
 Metal dust can contain chemical substances that can have a negative effect on health.
Work on the machine should only be carried out in well-ventilated rooms. If necessary,
use a suitable extraction system.
 If there are connections for dust extraction, make sure that they are properly connected
and in working order.
 Always work with care and the necessary caution and never use excessive force.
 Do not overload the machine!
HOLZMANN MASCHINEN GmbH
 A self-locking Emergency Stop button on the control unit to stop
dangerous movements at any time.
 A chuck guard (1) with position switch which covers the drill
chuck used and the clamped tool in its rest position at the front
and on both sides. The machine only switches on when the
chuck guard is closed.
 A protective cover with position switch (2) for the drive unit and
the switch box. The machine only switches on when the
protective covers are fitted and the position switches are
activated.
www.holzmann-maschinen.at
SAFETY
40
BF500D | BF500DDRO