Safety Devices; Residual Risk Factors - HOLZMANN MASCHINEN FS 160L Mode D'emploi

NO ELECTRICITY
before servicing.
Check and follow the instructions! Non-compliance may result in serious injury or
death! HOLZMANN MASCHINEN machines can not be held liable for accidents if safety
instructions are not be followed!
11.4

Safety devices

In the design of the machine following protective devices are provided:
milling guard:
 The milling guard is present to a contact to avoid the router.
 The cutter fence used to accurately guide the workpiece during longitudinal milling. It is
also produced by destructible material (aluminum).
 Maintenace door with limit switch. While the belt change, with the door open, the
machine can not start.
 Electronic brake for electrodynamic braking of the motor. Backs up the tool in less than
10 seconds to slow down after the drive off.
11.5

Residual risk factors

Also in compliance with all safety regulations and when used following residual risks are
considered:
 Risk of injury for hands / fingers through the router during operation.
 Risk of injury from contact with live components.
 hearing loss, unless arrangements have been made by the user for hearing protection.
 Risk of injury to the eye by flying parts, even with goggles.
 Using blunt tools is not allowed because of kickback, Überla Maintenance of the
machine and produce poor surface during processing.
 When milling of workpieces 120 mm width supplying the material with a push stick
must be made.
 Danger due to inhalation of toxic wood dust in chemically treated workpieces.
These risks can be minimized if all safety rules are applied, the machine is properly maintained
and serviced the machine as intended and is serviced by a trained service professional. Despite
all the safety devices and remains her good common sense and your appropriate technical
qualification / training on the operation of a machine such as the sliding Spindle shaper FS 160L
is the most important safety factor!
HOLZMANN MASCHINEN GmbH
! The machine from the power source must be disconnected
www.holzmann-maschinen.at
D A N G E R
SAFETY
32
FS 160L