Maintenance And Care; Cleaning; Disposal - HOLZMANN MASCHINEN FS 160L Mode D'emploi

14

MAINTENANCE AND CARE

Don't clean or do maintenance on the machine while it is still connected to the
power supply:
Damages to machine and injuries might occur due to unintended switching on of the
machine!
Therefore: Switch the machine off and disconnect it from the power supply before
any maintenance works or cleaning is carried out
The machine is low maintenance and contains little parts that must undergo a maintenance
operator.
Faults or defects that may affect the safety of the machine, must be rectified immediately.
Repair work may only be performed by qualified personnel!
The complete and utter cleaning ensures a long life for the machine and represents a safety
requirement.
After each shift the machine and all its parts must be thoroughly cleaned by the dust and swarf
sucked through the suction system and all other waste is disposed of by compressed air.
Check regularly that all warning and safety instructions on the machine and available in a
perfectly legible condition.
Check before every use the perfect condition of the safety devices.
For storage of this machine may not be stored in a humid room and must be protected from the
influence of weather conditions.
The elimination of defects does your dealer
Repair work may only be performed by qualified personnel!
14.1

Cleaning

The use of solvents, harsh chemicals or abrasive cleaners leads to damage to the machine!
Therefore: When cleaning water and mild detergent if necessary use.
Bare surfaces of the machine against corrosion impregnate ( with anti-rust WD40 )
14.2

Disposal

Do not dispose of the FS 160L in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local
dealer for a replacement unit, the latter is obliged to exchange your old
HOLZMANN MASCHINEN GmbH
A T T E N T I O N
N O T E
www.holzmann-maschinen.at
MAINTENANCE AND CARE
38
FS 160L