Maintenance Plan; Cleaning; Disposal; Trouble Shooting - HOLZMANN MASCHINEN SB4115N Mode D'emploi

14.1

Maintenance plan

After each workshift:
 Apply a thin layer of oil on the column and the table
 Remove drill cuttings and metal chips from the device
After 50 hours of operation
 Apply some fat on the angle drift
14.2

Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces
as well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution
14.3

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local
dealer for a replacement unit, the latter is obliged to exchange your old.
15

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Fehler
Motor does not run
Loud noice when running
Drill runs erratically
Drill is hot and smokes
Motor runs but no rotation or
weak drilling power
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
HOLZMANN MASCHINEN GmbH
Mögliche Ursache
 Incorrect power supply
 Switch defect
 Motor defect
 Safety switch activated
 Incorrect belt tension
 Drill chuck not assembled
correctly to arbour or one of them
is dirty
 Drill chuck jaws worn or damaged
 Spindle or boring is worn
 Too fast speed for material being
drilled
 Belt tension too low
 Pulley belt diry, slippery
www.holzmann-maschinen.at
N O T I C E
Let it be checked by a trained
person
Change
Change
Check the cover of motor pulley
(open?).
Adjust belt tension (1cm rule)
Check and adjust.
Change drill chucj
Check and replace if nesessary
Reduce speed
use lubricants
Tighten
Clean
TROUBLE SHOOTING
Behebung
34
SB 2516H