Rolling In / Collect The Hose; Settings; Adjust Tube Length; Change Position Of The Guide Arm - HOLZMANN MASCHINEN LSR10HQ Mode D'emploi

14.2

Rolling in / collect the hose

Further off hose is released to lock. Then slowly move the hose to the take-up reel.

14.3

Settings

14.3.1 Adjust tube length

The solid fixed length of hose with hose coupling can be set indefinitely.
Loosen the two cap screws on the hose-stop ring (1) carefully. Pull the tube out of the guide and

slide the hose-stop ring to the desired length.
Screw the two cylinder screws again


14.3.2 Change position of the guide arm

The position of the guide arm (9) is adjustable in 90° steps. Allows you to set parallel or angled
to the wall, floor or ceiling, the tube guide
By removing the 6 sided nut on the mounting and align the guide arm in the desired position.

the guide arm in position by tightening the 6 sided nut.


14.3.3 Adjusting the spring force

By adjusting the spring force of the return velocity of the tube can be adjusted individually. It
increases or reduces the effort to curl the hose off or on.
The air supply necessarily interrupt when adjustment, maintenance, and
repair work. Disconnect hose from the air supply!
ATTENTION: Always hold the hose reel in this setting and do not let go!
Remove the hose-stop ring (1) as described in 15.3.1

Pull the hose end out through the hose guide


14.3.4 Spring force reduce:

By turning the hose reel counterclockwise (seen on hose supply side), the spring force is relieved.


14.3.5 Increase spring force

By turning the hose reel to clockwise (seen on hose inlet side), the spring force is increased.

After adjust the spring tension pull the hose end through the hose roller guide and fix the stop
ring. Only now you can let go of the hose reel again!
15

MAINTENANCE

The hose reel is low maintenance and contains little parts that need maintenance
operator.
The air supply necessarily interrupt when adjustment, maintenance, and
repair work. Disconnect hose from the air supply!
The elimination of defects does your dealer
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
MAINTENANCE
in-a subject the
15
LSR10HQ, LSR15HQ