HOLZMANN MASCHINEN SB4115N Mode D'emploi page 28

ASSEMBLY
12.2 Assembly
The machine is delivered pre-assembled.
For transport reasons some components can be assembled by the customer (symbol-sketch).
Fix the base through the four provided
borings to the underground.
Fix the columns shoulder with hex bolts (3)
to the base (1).
Put the Column (4) into the table bracket.
Apply the rack (2) to the column shoulder.
Push the table bracket onto the rack (2) /
column (4). So that the handle (8)
mechanism is on the right side.
Insert the rack (3) end into the column
shoulder; pull the rack ring onto the
column (4) so that it fixes the upper side of
the rack. Fix the rack holder with the
setscrew (7).
Now assemble the table assembly to the
table bracket (5).
With the help of a second person, put the
drill assembly onto the column (4). Fix it
with hex screws.
Mount the three handles (6) to the handle
body.
Finally check the evenness of 90° of gear
assembly to base.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 28
SB 2516H