Residual Risks; Transport - HOLZMANN MASCHINEN BF500D Mode D'emploi

15.8

Residual risks

 Formation of a flow chip
- This wraps around the forearm and causes severe cuts.
 Throwing away workpieces or tools at high speed.
- Always check workpieces for suitability and clamp them securely and firmly
 Risk of tripping due to supply lines on the floor.
- Properly route supply lines and cables
- Mark unavoidable tripping hazards yellow-black
Irrespective of all safety regulations, your common sense and appropriate technical
suitability/training are and will remain the most important safety factor for error-free operation of
the machine. Safe working primarily depends on you!

TRANSPORT

Damaged or insufficiently strong hoists and load slings can result in serious injury or
even death. Before use, therefore, check hoists and load slings for adequate load-
bearing capacity and perfect condition. Secure the loads carefully. Never stand under
suspended loads!
To ensure proper transport, observe the instructions and information on the transport packaging
regarding centre of gravity, attachment points, weight, means of transport to be used and the
prescribed transport position, etc.
Transport the machine in its packaging to the place of installation. To manoeuvre the machine in
the packaging, a pallet truck or forklift truck with the appropriate lifting force can be used, for
example. Ensure that the selected lifting equipment (crane, forklift, pallet truck, load sling, etc.) is
in perfect condition. Lifting and transporting the machine may only be carried out by qualified
personnel with appropriate training for the lifting equipment used.
HOLZMANN MASCHINEN GmbH
WARNING
1. Place the load slings around the machine to prevent it
from slipping (see picture on the left).
2. Place soft, non-slip materials between the load slings
and the machine.
3. Align the load slings lengths so that the machine is
horizontal and stable when lifted.
4. Bring the worktable into the maximum outermost
position to the machine body in the longitudinal axis.
5. Bring the worktable into centred position in the
transverse axis.
6. Lock the machine completely.
7. The load slings must not touch the machine body, lever,
etc.
8. Gently lift the machine to avoid shocks and load
fluctuations and carefully transport it to the installation
site.
www.holzmann-maschinen.at
TRANSPORT
42
BF500D | BF500DDRO