Cutter Selection; Clamping The Milling Tools - HOLZMANN MASCHINEN BF500D Mode D'emploi

Type N (normal)
For materials up to 1000 N/mm
light metal alloys, plastics such as PS, PC, PMMA, )
Type W (soft)
For soft materials (copper, light metals zinc alloys, lead, plastics such as PVC, POM, PTFE, PE,
PP).
19.7.4

Cutter selection

Factors that affects the choice of tool are:
 The workpiece contour (shape and size). If axial plunging into the material is required,
center-cutting tools must be used (usually 2- or 3-cutting end mills).
 The type of machines available (power and stability).
 The material to be machined
 Cutting performance and surface quality
Examples:
19.7.5

Clamping the milling tools

Correctly clamped and mounted cutters are a prerequisite for good and safe milling
work. Always clamp the milling cutter as short as possible. All cones and cutters must
always be cleaned and checked before insertion. After clamping, check the radial and
axial run-out of the milling tools.
HOLZMANN MASCHINEN GmbH
2 tensile strength (cast steel, malleable cast iron, stainless steels,
Slot milling cutters
(2 or 3 cutting edges)
with center grinding
Angle milling cutter
for milling angle
guides
Shell end mill for
milling corners and
flat surfaces
NOTICE
www.holzmann-maschinen.at
OPERTATION
End mills for deep
slots
(without center
grinding)
T-slot milling cutter
for milling T-slots
Angular face milling
cutter for milling
angular guides
54
BF500D | BF500DDRO