Blind Hemming - Janome DC4030 Manuel D'instructions

q
w
z
q
(1)
x
(1)
t
w e
w
q
(2)
c
r
e
(2)
r

Blind Hemming

q Stitch pattern:
w Thread tension dial:
e Presser foot:
z Fold a hem with the wrong side of the fabric up to form
a 0.4 – 0.7 cm allowance.
q Wrong side of fabric
w 0,4 – 0,7 cm
(1) Fold the hem under the fabric for lightweight fabrics.
(2) On heavyweight fabrics that tend to ravel, the raw
edge should be overcast first.
x Place the fabric so that the fold is next to the guide on
the foot. Lower the presser foot. Adjust the needle drop
position if necessary. Sew while guiding the fold along
the guide.
e Fold
r Guide
c Open the fabric after sewing is finished.
NOTE:
If the needle pierces too far left, the stitch will show
through on the right side of the fabric.
• Adjusting the needle drop position
The needle drop position can be adjusted by pressing
stitch width adjusting button.
(1) Press the minus (–) key to move the needle drop
position to the right.
(2) Press the plus (+) key to move the needle drop
position to the left.
The indicator window will show the distance between the
guide and left needle drop position in millimeter.
r
Guide
t
Left needle drop position
NOTE:
The needle drop position will move to the left or right,
but the stitch width is remained the same.
62
A
Blind hem foot: G