Janome DC4030 Manuel D'instructions page 54

c
t
y
z
a
s
d
f
x
c
t Mark for placement of buttonhole
u
y Starting point
u Slider
i
i There should be no gap.
o Stopper
o
!0 Difference
c Raise the foot. Insert needle thread through slot in foot.
Draw both threads to left under the foot. Insert the fabric
under the foot, and lower the needle into the fabric at
the buttonhole starting point. Lower the buttonhole foot.
!0
If there is a gap i, it may cause an uneven buttonhole
stitch length as shown !0 .
• Starting to sew
z Start the machine to sew the buttonhole.
The buttonhole will sew a buttonhole in the following
order:
a Step 1 and 2: Front bartack and left row.
s Step 3: Right row..
d Step 4: Back bartack and locking stitches at the
f Indicator window shows each sewing step and a
If you start sewing the buttonhole without lowering the
buttonhole lever, the indicator will show a warning sign.
Lower the buttonhole lever, then restart the machine.
x Remove the fabric and place a pin just before the
bartack at each end, to prevent cutting bartacks. Cut
the opening with the buttonhole opener. Use an awl
to open the keyhole buttonhole.
c When finished, push the buttonhole lever up as far as
it will go.
If you select the other pattern without raising the foot, the
indicator window shows "UP" to warn you.
50
end.
dot will blink when the buttonhole is finished.