Janome DC4030 Manuel D'instructions page 26

Table des Matières

Publicité

x
x
n
c
z
v b
m
• Winding the bobbin
z Draw the thread from the spool.
x Guide the thread around the thread guide.
c Thread through the hole in the bobbin from the inside
to the outside.
v Put the bobbin on the bobbin winder spindle.
b Push the bobbin to the right.
The indicator window will show
n With the free end of the thread held in your hand,
depress the foot control. Stop the machine when it
has wound a few layers, and then cut the thread
close to the hole in the bobbin.
m Depress the foot control again. When the bobbin is
fully wound, it stops automatically. Return the bobbin
winder to its original position by moving the spindle to
the left, and cut the thread as shown.
NOTE:
The machine will not sew until the spindle has been
returned to the left.
NOTE:
Make sure that the carrying handle is not being raised
when winding the bobbin.
NOTE:
The machine motor automatically stops after 2 minutes
if you do not stop the machine.
22
sign.

Publicité

Table des Matières
loading

Table des Matières