Table des Matières
Publicité
q
q
q
w
w
e
w
e
q
e
w
q
Removing and Attaching the Foot Holder
CAUTION:
Turn off the power switch when removing or attaching
the foot holder.
q Thumb screw
w Foot holder
e Presser bar
•
To remove
Remove the thumb screw q by turning it
counterclockwise with a screwdriver.
•
To attach
Match the hole in the foot holder w with the threaded
hole in the presser bar e. Fit the thumb screw q into
the hole. Tighten the screw q by turning it clockwise
with a screwdriver.
Changing Presser Foot
CAUTION:
Turn off the power switch when changing the presser
foot.
q Snap-on button (red button)
w Groove
e Pin
•
To remove
Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot,
and press the red button q on the back of the foot
holder.
•
To attach
Place the selected presser foot so that the pin e on
the foot lies just under the groove w on the foot
holder. Lower the presser bar to lock the foot into
place.
Bobbin Winding
• Removing the bobbin
q Hook cover plate release button
w Hook cover plate
Gently slide the hook cover plate release button q to the
right and remove the cover plate w.
Lift out the bobbin.
• Horizontal spool pin
q Spool pin
w Large spool holder
e Small spool holder
Lift up the spool pin q. Place a spool of thread on the
spool pin with the thread coming off the spool as shown.
Attach the large spool holder w, and press it firmly
against the spool of thread.
The small spool holder e is used with narrow or small
spools of thread.
20
Publicité
Table des Matières
