Blind Stitch Hemming - Janome 3622s Manuel D'instructions

q
z
[A]
w
q
x
e
c
v
w
e
r t
2
y
[B]
w
q
r
t

Blind Stitch Hemming

q Pattern selector:
w Presser foot:
e Thread tension:
r Stitch length:
t Stitch width:
y Hem guide
z Fold up the hem and fold it back to from a 0.4
to 0.7 cm (1/4˝) allowance as illustrated.
q Wrong side of the fabric
w 0.4 to 0.7 cm (1/4")
[A] Heavy weight fabrics
[B] Fine or medium weight fabrics
x Lower the presser foot, then loosen the foot
holder screw to place the hem guide between
the screw and the shank of foot holder.
Tighten the screw making sure the wall of hem
guide is placed in the middle of the toes of the
presser foot.
e Screw
r Hem guide
c Raise the presser foot and place the fabric
under the foot so that the soft fold rests against
the wall of hem guide.
Lower the foot, then stitch slowly for better
control so that the zigzag stitches fall on the
hem allowance and pierce the soft fold. While
sewing, make sure the fold runs along the wall
of hem guide.
v Open the fold flat.
t Right side of the fabric
* If the needle drops far left, the stitches will show
on the right side of the fabric.
52
E or F
Zigzag foot
2–4
1–3
5