Getting Ready To Sew Connecting Machine To Power Supply; Before Using Your Sewing Machine; For Your Safety; Polarized Plug - Janome 3622s Manuel D'instructions

Table des Matières

Publicité

e
w
q
t
r
GETTING READY TO SEW
Connecting Machine to Power Supply
q Power supply plug*
w Power switch
e Outlet
r Machine socket
t Machine plug
Before connecting the power cord, make sure
the voltage and frequency shown on the machine
conform to your electrical power.
1. Turn off the power switch w.
2. Insert the machine plug t into the machine
socket r.
3. Insert the power supply plug q into the outlet e.
4. Turn on the power switch w to activate the
power and sewing light.
* The power supply plug included may differ from
the illustration.

Before Using Your Sewing Machine

Before using your sewing machine for the first
time, place a waste fabric under the presser
foot and run the machine with thread for a few
minutes. Wipe away any oil which may appear.

For Your Safety

* While in operation, always keep your eyes on
the sewing area. Do not touch any moving parts,
such as the thread take-up lever, handwheel or
needle.
* Always turn off the power switch and unplug
from the power supply:
- When leaving the machine unattended
- When attaching or removing any parts
- When cleaning the machine
* Do not place anything on the foot control,
when not sewing.

Polarized Plug

This appliance has a polarized plug (one blade
wider than the other). To reduce the risk of an
electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does
not fit in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the
proper outlet. Do not modify the plug in any way.
Foot Controller Model YC-482J-EC or TJC-150 is
used with this sewing machine.

Controlling Sewing Speed

Sewing speed can be varied by the foot control.
The harder you press on the foot control, the
faster the machine runs.
10

Publicité

Table des Matières
loading

Table des Matières