SCS Sentinel OPEN 2 Manuel D'installation page 67

> LEARNINg THE AUTOMATIC TRAVEL Of THE gATE - CTR57
CTR 57
Indicator
LED DL1
DL1
P1
Manually position the gate in its fully open
JP2
position (figure 1).
Use the manual unlocking system or a 12V
1 battery to put the motors in position.
NB: mandatory central and side stops
(non supplied)
Press P2 during 2 seconds (on the electrical
portection's cover. The motors open during
1 second 1
2 the gate. After 5 seconds, the motor M2 starts
closing .
2
(figure 2)
Wait for the leaves to be completely closed and
check that each motor stops on the central
3
limit stop, after 2 seconds of thrust. (figure 3)
In case of error :
If at step 2, the motors start closing (to 30 cm), stopping, then openning : invert the motor's polarities
(invert the MOT 1 wire and MOT 2 wire).
EN ::: 25
Keys P1, P2 and P3
P2 P3
Potentiometer RV1
RV1
then the motor M1 starts closing
During gate travel learning,
all safety devices are
ignored.
Take all necessary
precautions and keep
everyone away from the
24V
installation.
Position the potentiometer
12V
BATT
RV1 to 3/4 of its travel
Mandatory
FS2 FS1 FS3
central stop
FS4
- BATT+
Mandatory
side stop
fIgURE 1
Mandatory
side stop
MOT 1 1
after s
MOT 1
fIgURE 2
fIgURE 3
24V
12V
Mandatory
side stop
Mandatory
side stop
1
MOT 2 1
after s
2
MOT 2
after 5s
EN FR