Mounting Steps - SCS Sentinel OPEN 2 Manuel D'installation

EN
> MOUNTINg STEPS :
1
ATTACH THE SUPPORT PLATES TO THE PILLARS
Fix the support plate respecting fitting dimensions
page 18.
ATTENTION :
Use flush fitting counter sunk screws and wall
plugs suitable for the pillar's contruction type
in order to guarantee the motor's complete
stability.
2
fIXINg Of ARM ON MOTOR
Place the arm on motor as shown.
1. Motor block
2. Pin
3. washer M8x3x28
4. washer GROWER
5. screw M8x10
3
fIXINg MOTOR ON PILLAR
Place the motor on pillar as shown.
1. hexagon head cap screw
2. washer
3. nut
EN ::: 20
screws
(not supplied)
P I L L A R
2
3
4
5
1
2
3
P I L L A R
1