SCS Sentinel OPEN 2 Manuel D'installation page 75

WIRELESS KEYBOARD
Nb
Setting up the remote controls does not suffi ce to make the system function correctly.
You must perform LEARNING OF ThE GATE'S TRAVEL (see p. 25)
1 gently remove the front of the
keyboard using the notch under it.
Then unscrew the two screws with a
screwdriver (fi g. c).
2 Place the keyboard near the electronic
box and far from any metal structures.
Your gate must be closed.
3 Move the jumper on terminals B and C
to A and B. The keyboard lights up and
beeps (fi g. d).
4 Stand in front of the printed circuit
board and locate button P1 and
indicator DL1.
5 Press P1 and release. Indicator DL1
lights up, goes out and lights up again.
6 While DL1 is lit, enter your code then
confi rm with the OK button on your
keyboard. You code should be
between 1 and 9999*.
7 Indicator DL1 goes out. Your keyboard
is programmed. Your gate opens.
* The code and «OK» confi rmation must be entered quickly before DL1 goes out, otherwise you have to start again.
How to erase the keyboard programming:
Press and hold down P1 until indicator DL1 goes out (for about 10 seconds). The programming of the
keyboard is now erased (as are all your remote controls).
CAUTION
Erasing the programming of your keyboard erases the keyboard and all the remote controls. You
must then re-programme the remote controls (see page 26).
How to add a new code to the keyboard:
You can enter up to 10 codes in the keyboard. Repeat the programming procedure. However, you
cannot erase just one code. You have to erase the programming of the keyboard (see above).
CAUTION: if your keyboard does not respond or if the keyboard can not be
programmed:
Press 00000 and 'ok' = 1 bip.
Press 99999 and 'ok' just one time = no bip.
Press 6
Then try to reprogram the keyboard.
EN ::: 33
EN FR
fi g. c
fi g. d