Operating The Under-Bench Air Conditioner; Basic Notes On Operation; Using The Remote Control - Dometic FreshWell2000 Notice D'utilisation

FreshWell2000
8 Operating the under-bench air
conditioner
8.1

Basic notes on operation

The under-bench air conditioner has three operating modes:
Operating mode
Stand-by
On
The receiver switches on when it receives pulses from the remote control.
The display shows (flashing) the temperature setting, after 10 seconds the
display shows the room temperature, then it switches off.
You can use the remote control to
z switch the under-bench air conditioner to and from stand-by mode.
z adjust the settings.
z select additional functions.
8.2

Using the remote control

The remote control must be pointed at the IR receiver (fig. 2
the receiver during operation.
When a button is pressed, the value is transmitted directly to the under-bench
air conditioner. The under-bench air conditioner confirms the receipt of data
with a high note.
Switching only the remote control to or from stand-by
In stand-by mode, the remote control display shows only the time.
If the remote control is not pointing to the IR receiver (fig. 2
the control panel, you can activate the remote control or switch it to stand-by
independently from the under-bench air conditioner:
➤ Press the
button.
EN

Operating the under-bench air conditioner

Features
The under-bench air conditioner is ready for operation and can
be switched on with the remote control.
The under-bench air conditioner is conditioning the air in the
interior.
page 3) on
4,
page 3) on
4,
19