Hint For Improved Use; Switching The Under-Bench Air Conditioner On And Off - Dometic FreshWell2000 Notice D'utilisation

Operating the under-bench air conditioner
8.3

Hint for improved use

The following hints will optimise the performance of your under-bench air
conditioner:
z Improve the heat insulation of your vehicle by sealing gaps and hanging
reflective blinds or curtains on your windows.
z If the vehicle has been subjected to direct sunlight for a long time: Operate
the under-bench air conditioner in the "Circulating air" (
windows open for a while before switching on the "Cooling" (
ditioning mode.
z Avoid opening doors and windows as far as possible in the "Cooling" (
mode.
z Select an appropriate temperature and blower speed.
z Align the air nozzles sensibly.
z Make sure the air nozzles and intake grille are not covered by cloths,
paper or other objects.
z Clean the air filter periodically.
8.4 Switching the under-bench air conditioner on and
off
I
NOTE
z When it is switched on, it begins to condition the air to the
values that were set most recently.
z You can use the remote control to switch the under-bench air
conditioner to and from stand-by mode. Press the
z You can operate the under-bench by remote control and via
LIN bus. If you use LIN bus control the receiver is not required.
z Don't use the under-bench air conditioner if the vehicle is tilted
more than 10°.
When you switch on the under-bench air conditioner, the device waits a few
minutes before operating the compressor.
20
FreshWell2000
) mode with the
) air con-
)
button.
EN