Intended Use; Technical Description; Fitting The Camera - Dometic PERFECTVIEW CAM35 Instructions De Montage Et De Service

Intended use

4 Intended use
The double camera CAM35 is primarily intended for use in the vehicles Fiat Ducato, Citroën Jumper, Peugeot
Boxer starting from model year 2006 with single roof. The camera console is mounted between the bodywork and
the brake light. It can be used in video systems to observe the space around the vehicle from the driver's seat when
maneuvering or parking, for example.
This product is only suitable for the intended purpose and application in accordance with these instructions.
This manual provides information that is necessary for proper installation and/or operation of the product. Poor
installation and/or improper operating or maintenance will result in unsatisfactory performance and a possible fail-
ure.
The manufacturer accepts no liability for any injury or damage to the product resulting from:
• Incorrect assembly or connection, including excess voltage
• Incorrect maintenance or use of spare parts other than original spare parts provided by the manufacturer
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in this manual
Dometic reserves the right to change product appearance and product specifications.
5

Technical description

The reversing camera and the long-distance camera (only CAM35 TWIN) are housed in one console for the orig-
inal brake light. The camera image is transferred to a monitor via a system cable. The CAM35 is also suitable for
connection to the original Fiat navigation system Uconect, as the cameras provide an NTSC video signal.
The camera consists of the following elements:
No. in
fig. 8, page 5
1
2
3
4
Only for CAM35 TWIN
In the CAM35 TWIN, a monitor with two video inputs must be connected that can be switched between the image
of the reversing and the long-distance cameras.
The long-distance camera transmits the image as if you were looking in the rear view mirror.
Only for CAM35 NAV
The cameras CAM35REAR NAV and CAM35 TWIN NAV can be connected to monitors from other manufacturers.
A universal adapter is included (CAM35 NAV adapter).
6

Fitting the camera

6.1 Dismantling the brake light
1. Remove the two screws of the brake light (fig. 9, page 5).
2. Remove the plug of the brake light (fig. 0, page 6).
12
Description
Reversing camera
Long-distance camera (only CAM35 TWIN)
6-pin connection cable for long-distance camera (only CAM35 TWIN)
6-pin connection cable for reversing camera
CAM35
EN