Safety And Installation Instructions - Dometic PERFECTVIEW CAM35 Instructions De Montage Et De Service

Safety and installation instructions

2 Safety and installation instructions
!
WARNING!
Danger of personal injury by vehicle.
Reversing video systems are designed merely as an additional aid for reversing, how-
ever this does not relieve you of the duty to take proper care when reversing.
Please observe the prescribed safety instructions and stipulations from the vehicle manufacturer and
service workshops.
Please note the following:
• To prevent the risk of short circuits, always disconnect the negative terminal of the vehicle's electrical system
before working on it.
If the vehicle has an additional battery, its negative terminal should also be disconnected.
• Inadequate supply cable connections could result in short circuits, causing:
– Cable fires
– The airbag being triggered
– Damage to electronic control equipment
– Electrical malfunctions (indicators, brake light, horn, ignition, lights)
• When working on the following cables, only use insulated cable terminals, plugs and flat sockets:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
– 58 (reversing light)
Do not use porcelain wire connectors.
• Use a crimping tool to connect the cables.
• Screw the cable when connecting cable 31 (earth)
– Screw on the cable using a cable terminal and serrated washer to one of the vehicle's earth bolts or
– Screw the cable to the bodywork using a cable terminal and a self-tapping screw
Make sure there is a good earth connection.
If you disconnect the negative terminal of the battery, all data stored in the volatile memories will be lost.
• The following data must be reset, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the operating manual.
Observe the following installation instructions:
• Secure the parts of the camera which are installed in the vehicle in such a way that they cannot become loose
under any circumstances (sudden braking, accidents) and cause injuries to the occupants of the vehicle.
• Secure any parts of the system concealed by the bodywork in such a manner that they cannot be come loose
or damage other parts or cables, or impair vehicle functions (steering, pedals, etc).
• To prevent damage when drilling, make sure there is sufficient space on the other side for the drill head to
emerge.
• De burr all drill holes and treat them with a rust-protection agent.
10
CAM35
EN