Fitting The Parking Aid; Connecting The Parking Aid - Dometic MAGICWATCH MWE 820 Instructions De Montage Et De Service

MWE820, 860, 890
6

Fitting the parking aid

See fig. 7 to fig. a
Supplementary to fig. 8
A
NOTICE! Risk of paint damage!
• The ambient temperature may not fall below 18 °C when punching
or drilling.
• We recommend using a punching tool.
• Make sure that you do not tilt the punching tool when operating.
➤ Deburr the drill holes.
➤ For a more accurate fit, slant the drill downwards slightly on the inside of the
bumper when drilling the hole. The sensor housing can now be easily inserted at
a downward angle.
Supplementary to fig. 9
A
NOTICE! Risk of malfunction
Note that the sensors must be aligned in a particular direction. The top
of the sensor is marked with an ▲.
7

Connecting the parking aid

I
NOTE
• MWE820, 860: On some vehicles, the reversing light only works
when the ignition is switched on. In this case, you must switch on the
ignition in order to identify the positive and earth wires.
• MWE890: If the speed signal has been connected to the control
electronics, the sensors are automatically deactivated at a speed
over approx. 15 km/h.
The sensors are reactivated as soon as the speed falls below approx.
15 km/h.
EN
Fitting the parking aid
7