Factory Setting - ENAG CDS3 12V/80A Manuel D'utilisation

3.3.3. Factory setting

The charger's factory settings are:
Sealed type battery (lead sealed)
BOOST in ON position
The installer should set the selection wheel (RC1) (excluding input and output voltage) and possibly adjust
the output voltage with no load using potentiometer RV1 (use the appropriate tool to turn the screw of the
potentiometer), depending on:
- the type of battery (contact the battery manufacturer if necessary)
- the intended usage
- the cross-section and length of the output cables
- whether or not the boost function is required
For special batteries, call in a professional installer, who will make the specific settings in accordance with
the accumulator manufacturer's specifications and according to the specifics of the installation.
ENAG disclaims any liability in case of damage to batteries or ineffective recharging.
CDS3-3M-DEE 36