Other Type Of Installation; Selection Wheel And Switch Settings; Description; Adjustment Indicators - ENAG CDS3 12V/80A Manuel D'utilisation

3.2.6.2.

Other type of installation

Refer to appendix 3.
3.3.
S – -
ELECTION WHEEL AND SWITCH SETTINGS ADJUSTMENT INDICATORS

3.3.1. Description

The CDS3 chargers are equipped with a selection wheel (RC1) allowing to set up the charger according the
battery type and the application.
Setting thanks to a small flat head screw driver (width 2,5mm) and turn in clockwise direction.
RC1: Selection of the load curves
The CDS3 chargers are equipped with a Boost function for a faster charge of the batteries. This function is
controlled by a timeout (see table here after) and is automatically inhibited when the battery is fully charged
: stoppage of the boost for I batteries < 15% of I rated charger.
The Boost function can also be disabled by means of a switch (SW1).
Setting by selecting the switch
SW1 : Selection of the BOOST function
CDS3-3M-DEE 34