Precautions Regarding Electromagnetic Disturbance Generated By The Appliance; Cabling Principle; Cabling Type; Other Type Of Installation - ENAG CDS3 Manuel D'utilisation

3.2.5. Precautions regarding electromagnetic disturbance generated by the appliance

Use shielded cables for all the connections (*). The shielding should be earthed at both the transmitting and
the receiving ends.
Keep cable length and shielding connections down to a minimum.
Route cables as close as possible to conductive parts ("loose" cables or loops should be avoided – cables
should be flattened against conductive parts).
Keep power cables separate from battery cables.
Keep power cables separate from control cables (at least 200mm).
The cables should only supply power to this appliance; any branch-off or short-out intended to power
another appliance are prohibited.
( )
* This is a recommendation for installation rather than an obligation. The installing electrician should
decide whether or not to use shielded cable depending on the EMC environment.

3.2.6. Cabling principle

3.2.6.1.

Cabling type

3.2.6.2.

Other type of installation

Refer to appendix 3.
3.3.
S

ELECTION WHEEL AND SWITCH SETTINGS

3.3.1. Description

The CDS3 chargers are equipped with a selection wheel (RC1) allowing to set up the charger according the
battery type and the application.
Setting thanks to a small flat head screw driver (width 2,5mm) and turn in clockwise direction.
RC1: Selection of the load curves
Entrée AC
AC input
Eingang AC
Entrada AC
Ingresso AC
Connexion batteries
(si configuration en chargeur)
Battery connections
(in case of charger setting)
Batterieanschluss
(Im Falle von Ladegerät-Konfiguration)
Conexión baterias
(en caso de configuración cargador)
Connessione batterie
(nel caso di configurazione sotto carica)
–
ADJUSTMENT
Parc batterie principal BAT 1
Principal battery pack BAT 1
HauptBatteriepärke BAT 1
Parque bateria principal BAT 1
Parcho batteria principale
23-04-09 N°10350 26A
-
INDICATORS
22