Operating-Presentation-Interfaces; Perating Principle; Verview Presentation; Ser Interface Area - ENAG CDS3 Manuel D'utilisation

2. OPERATING–PRESENTATION–INTERFACES
2.1.
O

PERATING PRINCIPLE

The design of the battery chargers in the CDS3 range is based on a high-frequency split converter that
transforms the AC signal into regulated and filtered DC current. They can operate as a DC power supply.
Once the type of battery and type of charge has been selected, operation of the battery charger is entirely
automatic (Unless otherwise specified by the supplier or the manufacturer of the batteries). It can remain
connected to the batteries and does not need to be disconnected when starting up an engine (marine
application), because it is equipped with insulating diodes.
The appliance's output voltage is sufficient to recharge batteries.
All the models are equipped with an additional + SP output allowing to add an external battery isolator in the
case of an installation of several battery banks.
Each output can deliver the rated current.
2.2.
O

VERVIEW PRESENTATION

The chargers are divided into 2 areas:
•
The user interface area
•
The energy conversion area (all maintenance in this area is forbidden except ENAG authorization, under
penalty of warranty exclusion)
•
Access to the user interface area:
2.3.
U

SER INTERFACE AREA

Refer to appendix 1.
User interface area open screw
Area of energy conversion
User unauthorized access
User interface area
19