Oscartielle DRAGO Mode D'emploi page 15

6. Frequency
7. Max absorbed current
8. Max absorbed power
9.
10. Standard lighting power
11. Net display area
12.
13.
14. Climate class and reference temperature (dry bulb)
15. Electrical safety factor
16. Work schedule number
17. Work order number
18. Year of manufacture
19. Heating capacity
20. QR code
21. EAC marking
Warning: The serial plate and the warning labels must never be removed from the unit. The Manufacturer cannot be held
liable for any damage or injury if this warning is ignored.
The Manufacturer states that this unit complies with Italian legislative degree n° 108 dated 25.01.1992, implementing
EEC Directive 89/109 concerning materials and objects that come into contact with food.
7 - Loading and use of the unit (start-up)
The display unit can only be started up for the very first time after complying with points 3 and 4 above.
With the unit unplugged, remove the plastic film protecting the insides and outside and then clean (follow the instructions
in point 9 below).
Fit the various shelf supports at the height required, as shown in FIG. 7a-7b. FIG. 1 shows the best distances between
shelves.
Plug in the unit (having followed the instructions in point 5), then switch on the lights and motor unit pressing the switches
located on the front bottom panel, under the decoration trim (see FIG. 6). The display (FIG. 6) on the front bottom trim
shows the working temperature of the display case. The instruction manual for the electronic control to which the display
refers is enclosed with the instruction booklet (tampering with this device is impossible because a password is required
and only a specialized expert can intervene on it). The thermostat is set at +75°C in the factory. Tampering with the
factory settings relieves the manufacturer of any liability.
About 1 hour after switching the cabinet on, you can start filling it with products. Always check that the temperature
reading on the display of the electronic control is suitable for the conservation of the products placed in the display
cabinet, namely +65°C for the most part of the foods. This temperature may continue the cooking of some kind of food, so
it is advisable to display small quantities of products during slow sales time.
The cabinet is designed for the display of food products, which are stored at the temperature of the product. It should not
keep them hot or cook them. The products must be displayed after cooking and at at a storage temperature eual and not
lower than +65°C.
Recommendations for storage:
- Never block the outlets that guarantee the correct flow of air (see FIG. 8).
- Display only one layer of products for each shelf.
8 - Prohibitions and requirements
Warning: disconnect the cabinet from the power supply in case it is not used. The power supply has to be disconnected
by the remote-control switch fitted upstream from the power socket.
Warning: Never expose the unit to the atmospheric agents. Never use direct water jets to clean the unit. Never touch or
use the unit with wet or damp feet and hands.
Warning: Never remove the protections or covers that require tools to be removed. Never, under any circumstances,
remove the cover on the electronic panel.
Warning: Never load the unit excessively. Never stand on the cabinet.
Warning: Any use of the unit not explicitly mentioned in this manual should be considered dangerous and the
Manufacturer cannot be held liable for any damage resulting from improper, incorrect or unreasonable use.
Warning: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the
type recommended by the manufacturer (IEC60335-2-89 and changes)
Warning: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
Warning: Children should be supervised to ensure that they do not play with the appliance.
Warning: Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
9 - Cleaning the unit
Warning: Unplug at the mains before cleaning and wait until the warm components are cold.
13