Messages - Sony WX-920BT Mode D'emploi

Sony | Music Center operation
Application name is mismatched with the actual
application in "Sony | Music Center".
 Launch the application again from the "Sony |
Music Center" application.
While running the "Sony | Music Center"
application via BLUETOOTH, the display
automatically switches to [BT AUDIO].
 The "Sony | Music Center" application or
BLUETOOTH function has failed.
 Run the application again.
The "Sony | Music Center" application is
automatically disconnected when the display
switches to [IPOD].
 The "Sony | Music Center" application on iPhone/
iPod does not support iPod playback.
 Change the source of the unit to other than
[IPOD], then establish the "Sony | Music
Center" connection (page 15).
The "Sony | Music Center" connection is
automatically disconnected when the USB mode
of the unit is changed to [ANDROID].
 The Android smartphone is not supporting
playback in Android mode.
 Set the USB mode of the unit to [MSC/MTP],
then establish the "Sony | Music Center"
connection (page 15).

Messages

The following messages may appear or flash during
operation.
INVALID
 The selected operation could be invalid.
READ: Now reading information.
 Wait until reading is complete and playback
starts automatically. This may take some time
depending on the file organization.
(underscore): The character cannot be
displayed.
For CD playback:
CD ERROR: The disc cannot be played. The disc will
be ejected automatically.
 Clean or insert the disc correctly, or make sure the
disc is not blank or defective.
CD NO DISC: There is no disc.
 Insert a disc containing playable files (page 22).
CD NO MUSIC: There is no playable file. The disc
will be ejected automatically.
 Insert a disc containing playable files (page 22).
CD PUSH EJECT: The disc could not be ejected
properly.
 Press  (eject).
or : The beginning or the end of the
disc has been reached.
For USB device playback:
HUB NO SUPPORT: USB hubs are not supported.
IPOD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start playback.
NOT SUPPORT ANDROID MODE
 A USB device not supporting AOA (Android Open
Accessory) 2.0 is connected to the unit while [USB
MODE] is set to [ANDROID].
 Set [USB MODE] to [MSC/MTP] (page 18).
USB ERROR: The USB device cannot be played.
 Connect the USB device again.
USB NO DEVICE: A USB device is not connected or
recognized.
 Make sure the USB device or USB cable is securely
connected.
27
GB