Connections And Start-Up - Steinbach WP 14000 Manuel D'installation

E N
•
Support and its location.
If the product is used with a filter, the latter must be downstream from the product.
If the product is placed outside it is advisable to put a simple cover to protect it from rain.
Make sure the product is positioned in a place where noise generated during normal operations does not
create disturbances.
The product must run in a horizontal position. Make sure its position is not altered once it is correctly
placed.
The product must be fixed on a firm base, with screws of 6 [mm] diameter, through the prepared holes in
the foot.
The product must be positioned in a shady and aerated place.

5.6 Connections and start-up.

The electrical system must meet current international and/or national regulations.
The product must be connected to an power outlet equipped with a residual current device with
sensitivity over 30 [mA]. Before starting the product make sure this device is installed in your electrical
system. Contact a technician if necessary.
Nome file:
7528001 - ISTRUZIONI WP - IT-EN-ES-FR-DE-NL-ES
File name:
Fig. 50
Fig. 51
OUT
Fig. 52
M6
M6
Fig. 53
30-102
IN
IN
Rev. 0 05/10/2015