Chain Maintenance - Ryobi RY3818 Manuel D'utilisation

as a guide to help determine the correct warm
chain tension.
NOTE: New chains tend to stretch; check
the chain tension frequently and tension as
required.
NOTICE:
A chain tensioned while warm may be too tight
upon cooling. Check the "cold tension" before
next use.

CHAIN MAINTENANCE

See Figures 44 - 45.
CAUTION:
Stop the engine and disconnect the spark plug
wire before you work on the saw to avoid acci-
dental starting and possible serious personal
injury.
Use only a low-kickback chain on this saw. This
chain provides kickback reduction when properly
maintained.
For smooth and fast cutting, maintain the chain
properly.
The chain requires sharpening when the wood
chips are small and powdery, the chain must be
forced through the wood during cutting, or the
chain cuts to one side. During maintenance of the
chain, consider the following:
 Improper filing angle of the side plate can
increase the risk of severe kickback.
 Depth gauge clearance.
• Too low increases the potential for kickback.
• Not low enough decreases cutting ability.
MAINTENANCE
 If the cutter teeth hit hard objects such as nails
and stones, or are abraded by mud or sand
on the wood, have a qualified service center
sharpen the chain.
NOTE: Inspect the drive sprocket for wear
or damage when replacing the chain. If signs
of wear or damage are present in the areas
indicated, have the drive sprocket replaced by
a qualified service center.
NOTE: If you do not fully understand the correct
procedure for sharpening the chain after reading
the instructions that follow, have the saw chain
sharpened by a qualified service center or replace
with a recommended low-kickback chain.
Page 29 — English
DEPTH GAUGE CLEARANCE
.025 IN.
(0.6 MM)
Fig. 44
INSPECT DRIVE
SPROCKET
Fig. 45