Velleman HAA9523S Mode D'emploi page 5

** The output activation beep can be enabled or disabled through programming options at location 82.
4. Reset master code
If you have forgotten the master code, you can reset it. For the master code, do not use a combination that is already
taken for a user code.
If the personal master code is forgotten, use the DAP jumper to override the forgotten code permitting direct entry
into programming mode. You are required to apply the following procedure precisely:
1. Disconnect power supply.
2. Displace the DAP jumper from OFF to ON.
3. Reconnect power supply (buzzer is activated).
4. Put the DAP jumper back to OFF position (this done, the buzzer is de-activated).
5. The Keypad is in programming mode and ready to receive your new programming data.
6. Enter a new 4-digit master code at location 0 in case you have forgotten the old master code.
7. Enter the new programming data starting from Section B) in the summary chart shown below.
5. The Factory-Set Master Code – Important Note
When programming for the first time, the master code 0000 shall be used. In all cases, program a new master code
to invalidate the old master code and to ensure security.
6. Programming the Keypad – Summary Chart
A) Use the factory-set master code entry in programming -- When starting for first time only
Entry of code
B) Set the system to single or multi-user mode and refresh the system – Installer programming
Entry of code
C) Record the personal master code and user codes – User programming
Notes: master code
•
When programming the codes, it is recommended to program the master code before the user codes.
•
If you are programming a new master code, do not use a combination that is already taken for a user code.
•
If you have forgotten the master code, you can reset it. See section 4.Reset master code)
Notes: user code
•
Any user code must be different from the master code.
•
It is recommended to program a different code for every user.
1. Single user – Digits may be repeated
v2 15/11/2013
Validation Comments
Enter in programming mode by factory set master code
Validation Comments
Set the system to single user mode, clear all previously stored
data and refresh system
Set the system to multi-user mode, clear all previously stored
data and refresh system
HAA9523S
5 VELLEMAN