Festo DGCI Série Notice D'utilisation page 30

DGCI−...
For fastening the drive:
Use:
S
profile fastenings (centre supports) MUC or
foot fastenings HPC in combination with additional profile fastenings MUC.
The following table shows the minimum number of profile and foot fastenings.
Stroke range
100 400
401 600
601 1200
1201
1401
Fig. 5
Please note
If the distance between the profile fastenings is too large, the positioning
accuracy will be reduced.
S Use at least the number of fastening elements specified in Fig. 5.
The number differs from that specified for the linear drive DGC.
S Make sure that the plates are arranged as follows:
exactly flush (e.g. with a ruler).
equally distributed over the complete drive length.
30
Number of fastening elements
Profile fastening
2
2
3
1400 3
2000
4
Foot Profile
fastening + fastening
2 0
2 1
2 1
2 2
2 2
Festo DGCI−... 0801a English