Troubleshooting; Repairs, Spare Parts - XciteRC one10MT Mode D'emploi

Troubleshooting

Problem
EN
Motor does not
run
Vehicle runs back-
wards
Weak motor / no
power
Vehicle is hard to
control
Vehicle has no
function
Vehicle runs very
loud

Repairs, Spare parts

Normal wear and defective parts that result from an accident, are excluded from the warranty. These include
22
Possible Cause
Motor cable unplugged or broken
Drive battery empty
Throttle trim TH.TRIM on the transmitter
set incorrectly
Motor broken
Motor wiring reversed
Battery is almost empty
Throttle trim TH.TRIM on the transmitter
set incorrectly
Drive train does not run smoothly
Vehicle is very loud
Motor gets very hot
Transmitter LED is flashing - transmitter
batteries almost empty
Steering trim ST.TRIM on the transmitter
set incorrectly
Interference
Throttle trim TH.TRIM on the transmitter
set incorrectly
LED on the transmitter does not light up
Transmitter - receiver not bound (trans-
mitter LED flashing)
Interference
Throttle trim TH.TRIM on the transmitter
set incorrectly
Car aerial torn off
Transmitter LED is flashing - transmitter
batteries almost empty
Drive battery empty
Gear mash between the pinion and main
gear set incorrectly
Worn gears
Bearings runs tight or worn out
Troubleshooting · Repairs
Solution
Insert the motor cable or solder
Change or charge the battery
Check transmitter, set trim correctly
Replace the motor
Check motor cable and reconnect if ne-
cessary
Change or charge the battery
Check transmitter, set trim correctly
Check drive train and clean if necessary
Check pinion clearance, adjust if neces-
sary
Allow motor to cool; check drive train for
binding parts and precise gear mesh
Change or charge the battery
Check transmitter, set trim correctly
Turn off the vehicle and transmitter, make
a quick break and then re-try
Set throttle trim to the center position
Check that vehicle and transmitter are
turned on
Turn off the vehicle and transmitter and
then re-try
Turn off the vehicle and transmitter, make
a quick break and then re-try
Set throttle trim to the center position
Repair antenna (vehicle)
Change or charge the battery
Change or charge the battery
Check gear mesh adjust if necessary
Check and replace if necessary
Check and lubricate or replace if neces-
sary
One10 MT