Maintenance; Troubleshooting; Corrective Action - XciteRC Flybar 180C Coax Cam Mode D'emploi

Camera Operation · Maintenance · Troubleshooting
The data can be transferred via the micro SD memory card or via the USB socket and a suitable cable to
the PC.
Picture

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!

Troubleshooting

Problem Possible Cause
Rotor don't move ON/OFF switch is OFF
Weak helicopter battery
Rotor stops sud- Weak helicopter battery
denly, helicopter
chrashes
XciteRC Flybar 180SC Coax
You can capture single pictures or video. Once you press
the button for pictures, the red camera light goes on, the
Video
camera takes a picture. Press the video button to start
the video recording which runs until you press the button
again. The red LED lights up while recording.

Corrective Action

Switch ON helicopter
Re-charge battery
Re-charge battery
EN
19