Landing; Maintenance; Troubleshooting - XciteRC EUROCOPTER Tiger iBlast Mode D'emploi

Forward - backward
Move the right stick forward, the helicopter fl ies forward. Move the joystick backwards to fl y backwards.
EN
Left - Right
Move the right stick to the left, the helicopter turns to the left. Move the joystick to the right to turn to the right.
Trim
Hoovers the helicopter in one direction, although the right joystick remains in the center position, this can be
compensated with the trim wheel on the upper right corner of the transmitter. Turn the trim wheel against the
direction of rotation of the helicopter until he is steady in the air.

Landing:

Carefully push the left throttle lever rearward. Try to land „smooth" without damaging the helicopter.
NOTE: if the fl ight battery runs empty, the helicopter does not respond accurately to your commands,
the fl ight is unstable. In this case land immediately.
Switch of the helicopter and then the transmitter.

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fi re hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fi re hazard!

Troubleshooting

Problem
iBlast module does
not work
EUROCOPTER
iBlast does not fl y
18
Possible Cause
Batteries almost empty
„Transmitter" App switched off
Flight battery almost empty
Broken main rotor blades
Main rotor blades mounted incor-
rectly
Broken main motor
Maintenance · Troubleshooting
Corrective Action
Charge battery
Switch App on
Recharge fl ight battery according to the
instructions
Change the main rotor blades
Check main rotor blades and mounting it
again after instruction
First check the transmitter and fl ight batte-
ry, if necessary, replace motor
EUROCOPTER iBlast